KAVAN UBEC 6A(10A max) 2-6S reguliatorius

Atskira UBEC plokste naudojama kai greičo reguliatoriaus BEC sistemos galingumo neužtenka reikiamam servo mechanizmų kiekiui arba naudojami labai galingi servai.

Specifikacijos:

UBEC-7A
Darbinė įtampa: 5.5v-35v lipo 2s-8s
Pastovi srovė: 6A
Momentinė srovė: MIN 7.5A 20 sec
Išėjimo įtampa: 5.25V +/- 0.5V
Svorisa: 18g

Switching Power Stabilizer BEC to power the receiver and servos that finds excellent application:

• in models with electric drive with OPTO governor
• in model gliders and models with an internal combustion engine, which is a classic receiver NiCd / NiMh 4- or 5-cell replaced Li-poly or Li-Fe
• in electric flying, the controller has a built-in BEC is powerful enough for a large number (more powerful, digital, etc.) servos

Using modern components and optimized circuit solution guarantees minimize interference RC rigs with low weight and small dimensions stabilizer. Supply voltage in the range of 6-25 V allows you to use UBEC with 6s Li-poly battery. The output voltage (5.0 V, 5.5 V or 6.0 V) is optional with shorting the jumper. Operating states LEDs show.

UBEC is equipped with protection against reverse polarity (UBEC Incorrect polarity does not work).

USING UBEC

• Electric motor with OPTO controller: UBEC connect directly to the outputs of the drive battery and UBEC output connector plug in the battery on the receiver.
• Model with an internal combustion engine or a glider UBEC connected directly to the output of a battery UBEC output connector plug in the battery on the receiver.
• Electric motor with controller with built-in stabilizer supply (BEC) before connecting UBEC must disconnect the red wire (+) in servo cable controller to drive out feature built-in BEC. Wiring is UBEC same as in OPTO controller.

Tip: To reduce possible interference with UBEC in the model, place at least 5 cm away from the receiver. In models with FM or AM radio sets 27, 35 or 40 MHz may be appropriate output cable UBEC provide interference suppression ferrite ring.