GensAce Tattu TA3000 Dual Smart Charger 60A/3000W For 12S-14S Lipo/LiHV Smart Battery

INTRODUCTION

The TA3000 charger is equipped with intelligent features that enable it to recognize the Tattu 12S/14S with AS150U smart batteries. It automatically recognizes the parameters of the connected battery and can perform charging and discharging functions without manually setting it, and can detect the state of charge, state of health, and temperature of the batteries while adjusting the charge current accordingly. It has more functions such as over-temperature protection, overcurrent protection, overcharge protection, disconnection protection, and fast balancing.

In conclusion, it's made to extend the life span of the batteries.

SPECIFICATIONS

- charging Power: AC 110V Input: Max 1200W

                             AC 220V Input: Max 3000W

- Discharge Power: MAX 70W*2

- Charging Current: AC 110V Input: Max 40A

                                AC 220V Input: Max 60A

- Input Current: AC<15A

- Type of Battery: LiPo / LiHv / Smart Battery

- Cell Count: 12-14S

- Channel Count: 2 Channel 

- Balance Tolerance: ±20mV

- Display: 2.4 inch IPS Screen

- Operating temperature: 0~65 ℃

- Storage temperature: -20~60 ℃

- Fast charge mode voltage: LiPo: 4.2V; LiHv: 4.35V

- Input Protection: Over Current Protection

- Output Protection: Over Voltage / Under Voltage / Short Circuit / Over Temperature / Reverse Polarity

- Cooling System: Cooling Air

- External Upgrade Port: USB Port

- Dimensions: 276×154×216mm

- Weight: 6kg

OPERATION

The control panel is shown below. There is a display screen and push buttons.

The screen display area is used to view charger parameters, charging information, etc.
The push buttons are used for equipment operation.

NOTE

In the split-screen display state, long press the "Channel/Return/Start" button to start the charging operation, and long press the "Channel/Return/Start" button or the "Confirm/Set" button to stop the operation.

Always stop the charger before disconnecting the battery.  Failure to do so may cause internal charger damage.  

Always ensure that the battery is connected properly to the charger. Do not modify the charger or battery in any way and do not attempt to “force” the charger function. Failure to follow these instructions may cause fire and or property damage.

If you notice any unusual situation during charging (such as a swollen battery), be sure to stop the charging cycle or disconnect power from the charger.