Your cart
Jūsų krepšelyje nėra daugiau prekių
High torque/ultra high speed programmable digital micro servo with metal gears and twin ballraced output shaft. Ideal for cyclic of 380-420 class mini helicopters. An aluminium mid case for perfect cooling even under high loads.
Input voltage range 4.8-6.0 V (nominal).
Using the DSP-1 USB Digital Servo Programmer/interface for GO servos and the MKS PC software you can program a wide range of servo parameters:
Dead Band: The signal value can be allowed to change under the circumstance without affecting the angle of the output / servo arm. MKS Default = 1μs or 1.2μs
Lock: The setting when the servo does not receive the signal - Keep at the last angular position / The motor is released.
Max. Duty: The duty cycle of the motor will be limited within this value.
Pulse Lower: The minimum angular range will be limited within this command value.
Neutral: The setting of the neutral position.
Pulse Upper: The maximum angular range will be limited within this command value.
Boost: The steps of the motor when starting-up. The larger the value is, the more powerful the step of the motor during the start-up.
| Servo dimensions | Micro |
| Servo type | Digital |
| Programmable | Yes |
| Thrust at 4.8V [kg∙cm] | 3.8 |
| Thrust at 6.0V [kg∙cm] | 4.3 |
| Speed at 4.8V [s/60st.] | 0.07 |
| Speed at 6.0V [s/60st.] | 0.058 |
| Control pulse width in neutral [µs] | 1520 |
| Frame Rate [Hz] | 333 |
| Deadband [ms] | 0.001 |
| Servo gears | Metal |
| Ball bearings | 2× |
| High-voltage | No |
| Power supply [V] | 4.8 - 7 |
| Length [mm] | 23 |
| Width [mm] | 12 |
| Height [mm] | 27.25 |
| Weight [g] | 17.73 |
| Intended for | Aeroplanes,Helicopters |
