Your cart
Jūsų krepšelyje nėra daugiau prekių
Very high torque/ high speed programmable digital micro servo with metal gears with 2 jewel bearings and one oil-retaining bearing. The slim 10 mm servo case makes it particularly suitable for controlling ailerons and flaps in hand launch gliders, smaller gliders/hotliners and motor models.
Input voltage range 4.8-5.0 V (nominal).
Using the DSP-1 USB Digital Servo Programmer/interface and the MKS PC software you can program a wide range of servo parameters:
Dead Band: The signal value can be allowed to change under the circumstance without affecting the angle of the output / servo arm. MKS Default = 1μs or 1.2μs
Lock: The setting when the servo does not receive the signal - Keep at the last angular position / The motor is released.
Max. Duty: The duty cycle of the motor will be limited within this value.
Pulse Lower: The minimum angular range will be limited within this command value.
Neutral: The setting of the neutral position.
Pulse Upper: The maximum angular range will be limited within this command value.
Boost: The steps of the motor when starting-up. The larger the value is, the more powerful the step of the motor during the start-up.
| Servo dimensions | Micro |
| Servo type | Digital |
| Programmable | Yes |
| Thrust at 4.8V [kg∙cm] | 3.19 |
| Torque at 5.0 V [kg∙cm] | 3.32 |
| Speed at 4.8V [s/60st.] | 0.12 |
| Speed at 5.0 V [s/60st.] | 0.11 |
| Control pulse width in neutral [µs] | 1520 |
| Frame Rate [Hz] | 333 |
| Deadband [ms] | 0.001 |
| Servo gears | Metal |
| Ball bearings | None |
| High-voltage | No |
| Power supply [V] | 4.8 - 5 |
| Length [mm] | 22.5 |
| Width [mm] | 10 |
| Height [mm] | 23.8 |
| Weight [g] | 9.5 |
| Intended for | Aeroplanes |
