Graupner ULTRA PRO 2206 1600KV 2-6S Brushless Motor komplektas S7116 + S7116, CW + CCW

ULTRA 2806 1500KV Brushless M Graupner S7116 + S7116, CW + CCW



High performance motor for professional use on multicopter
Hand-wounded, brushless out-runner motors with a special multi-winding for optimal filling degree of the winding and thus optimum efficiency and optimized cooling.

Specially shaped, thicker and larger N52H magnets for up to 30% more torque and good temperature resistance.

Particularly stable and thicker motor shaft.
2206 motor stator installed. The motor size corresponds to the previous Graupner 2806 sizes, 28 mm outer diameter with 6 mm stack height.

Optimal weight/performance ratio. Less mass inertia thanks to the new M3 prop mounting.
PCB for easy soldering of the connection cables.

The 1600KV motors are particularly well suited for multicopter with 6.5 inch race props and 4S LiPo with higher capacity or for race copters with 6S LiPo and 5.5 inch race props.

Enclosed to the motor are a set of screws and a prop adapter for mounting the Graupner 3D-PROP and also for prevent slipping on the hub.

• Direction of rotation seen from the thread: CW left-hand thread

Specification
Magnet : N52H
Operating voltage range [V]: 7,4...26,1 V
Weight approx. [g]: 35 g
Height [mm]: 33 mm
Weight [g]: 35 g
Free shaft length [mm]: 5,5 mm
Cell count, LiPo, Lilo, LiFe: 2 - 6
Number of poles: 14
Nominal voltage [V]: 14,8 V
Case length: 20 mm
Recommended propeller: 5" - 8"
Shaft diameter [mm]: 5 mm
Case diameter: 28 mm
Revolutions / Volt [kV]: 1600
Brushless: Yes
Stator: 2206