Graupner ULTRA CONTROL 35A 2-4S BLHELI SBEC S3083.3D greičio reguliatorius XT60

The flight controller with SBEC

The Graupner Ultra 35 A SBEC is the ideal controller for all model aircraft that require a receiver power supply. The ULTRA 35 A SBEC combines compact design, low weight, fast response times and flight model optimized settings.
The controllers are factory programmed for bidirectional operation for forward and reverse.
The Ultra controller has installed the open source BLHeli Main software in version 14.x. The controller can of course also be flipped to BL Heli MULTI or TAIL. The flight controller is the only open source electronic speed control that uses the modern 50 MHz Silabs processors and can be set and updated with the Graupner Updatekable 7168.6, and a voltage divider (0.109) for voltage measurement with the intended receivers, e.g. S1034, S1035, 33576, 33577, 33506, 33508 or Copter Flight Controls (eg Betaflightsetting: 92). The processor has twice the clock rate of its predecessors. This guarantees higher maximum speeds and precise timing at high speeds.
The power amplifier is located in a 5 x 6 DFN package. The field effect transistors (FET) have an extremely low internal resistance. Special FET drivers provide a more effective active freewheel and better cooling of the power amplifier.
The special capacitors used allow for very fast start-up times and guarantee high operational safety.
The regulator paths are already optimized for the Graupner receivers.
The speed limit of the ULTRA controller is 400,000 rpm for 2-pole motors.
The SBEC is designed for 3A continuous current and tolerates short-term peak loads of up to 6 small servos.
An additional voltage sensor cable allows voltage measurement and warning with the Falcon 12, GR-12 in the CH5: Voltage setting, the GR-16 on Channel 6, and the GR-18 on Channel 9. This feature isabsolutely unique in this range of controllers Timely recognition of an empty battery and thus protects your model.

Characteristics:

• Open Source BL Heli Software 14.x.

• 50 MHz Silabs processor

• High-quality DFN 5x6 FET amplifiers

• Special FET driver

• Ceramic capacitors

• PPM receiver pulses and OneShot

• Multishot available via update

• Servo paths and settings for Graupner receiver optimized

• Programmable and updateable with Graupner update cable 7168.6 and BL Heli Suite

• Voltage sensor cable for voltage measurement with Falcon 12, GR-12, GR-16 and GR-18 receivers (not for GR-12L)

Specification
Width [mm]: 19 mm
Weight incl. leads [g]: 25 g
Max. continous current [A]: 35 A
Height [mm]: 8 mm
BEC [V / A]: 5,3/3 V/A
Pulse frequency [kHz]: 24 kHz
Weight [g]: 25 g
Battery plug connection: Cable
Cell count, LiPo, Lilo, LiFe: 2-4S
Overall length [mm]: 50 mm
Dimensions [LxWxH in mm]: 50 x 19 x 8 mm
Max. continous current [A]: 35 A
Field of application: Flugmodelle, Heli, Copter, Cars, Boats
Brushless: Yes