Discus 2a (870 mm) kit

Gliding is fun

Discus 2a was manufactured with the support of Schempp Hirth from the original data, except for the change in the Vector Unit section and adjusting the angle of adjustment of the wing to the tail plane is a 100% reduction of the 3-sided view. The imprint of this model was created from the original pictures of the aircraft, even the cockpit area with the pilot is 1: 1 from the original, which includes Andreas Belz, who in 2017 with this aircraft as the best German in the standard class won 8th place at the European Championships. Beam reinforcements are made of Spaltabdeckband, which carried the aircraft. The model is made of Vector Board and is printed, cut and packaged here in Germany.

Flight characteristics:

The model has very good flight characteristics.
The position of the vector unit is selected so that the model can be easily operated.

Construction:

It is set so that the model with full throttle holds the nose and rises slightly. If you remove the throttle, the model aircraft will go into a slight curve and slide to the ground.

Tuning:

For more performance, you can tune the Vector Unit with Extreme Motor No.34001.4 and a new 220 mAh battery No.78102.1 and use the same propeller as before.

Assembly:

Installation is limited to attaching the Vector unit using tape straps (not included in the kit) using self-adhesive rail reinforcement (see video instructions), inserting the wings and attaching the lift to the fuselage.

Kit contents:
1x hull, 8 mm vector plate
1x wing, vector board 3 mm
1x horizontal stabilizer, 3 mm Vector Board
2x bar reinforcement 700x6x0.35 mm

Technical details
Weight [g]: 27
Height [mm]: 80
Overall Length [mm]: 370
Material: Vector board
Wingspan [mm]: 870
Version: Vector Plane