Brushed electric motors of „FOXY Brushed“ range are perfect for a whole lot of model builder's applications - for powering aircraft, boat, car, tank and other ground vehicle models either with direct drive or with a gearbox.
When connecting and installing foxy motors, pay attention to the allowed voltage and load current limit.
Motor cooling: operating temperature of the housing shouldn't exceed 80°C. The model should always have sufficient air intake and air-flow around the motor. For boat models, we recommend using water cooling. High motor loads are possible only for short periods. After every driving/riding/flying session, you should let the motor cool down to a room temperature before the next ride/flight/drive.
FOXY 250 7.2 V is a brushed electric motor size "250" with a shaft with a diameter 2.0mm and plain bearings. It is suitable for powering indoor aircraft models or park flyers with direct drive (4.7x2.3" or 4x3" propeller) or with a gearbox for a small car and boat models.
For controlling the RPM, you will need an ESC with a load capacity of 8–12A.
FOXY 280 7.2V is a suitable replacement for a motor SPEED 280 7.2V (product number 7301).
Set contains:
- Brushed electric motor FOXY 280 7.2V
- User manual
Napětí (jmenovité) [V] | 7.2 |
Napětí (provozní) [V] | 3.7 - 7.4 |
Otáčky při jmenovitém napětí [ot./min] | 15500 |
Regulátor [A] | 8 - 12 |
Průměr [mm] | 23.8 |
Délka (skříně) [mm] | 30.5 |
Průměr hřídele [mm] | 2 |
Volná délka hřídele [mm] | 12 |
Hmotnost [g] | 42 |